Q-Mount Lightweight

More images

  • Q-Mount Lightweight
Click to enlarge
Q-Mount Lightweight
Product ID : Z-QML
Price: $198.00
E-mail to a friend | Add To Wish List



The Zacuto Q-Mount for 15mm lightweight spaced (60mm) rods clamps onto 15mm rods to create a stable mount for a lens support, articulating arm or 15mm rod. The Q-Mount can ‘snap’ onto rods with the clamps facing up or down and tightens with a quick release ratcheting lever on either side of the mount. It can be installed anywhere on a 15mm lightweight spaced rod system without you needing to remove any other accessories. At the center of the Q-Mount is a 15mm rod port controlled by its own quick release ratcheting lever. This rod port can accept any 15mm rod or a Zacuto articulating arm or Zud. Use a Zud to retrofit a Noga or Israeli arm to the Zacuto quick release system.

We use a Q-Mount to build our line of lens supports.

Product Reviews

Login or Register to write a review.
Reviewed by dustinp35
09/01/2015 - 04:32:17 PM
Top Notch
It's a nice light weight and has a lifetime warranty. The price is similar to the Wooden Camera, but this has the beautiful Zacuto anodized look which matches my Recoil. Great lens support system.
Reviewed by Orchard
05/04/2015 - 12:19:27 PM
Great monitor mount on rear rails
We had been using the longer Z-arms and a Z-rail to mount our Odyssey 7Q+ to our C100 Next Generation Recoil rig. We changed to this new setup using the lightweight Q-mount, a small Z-arm, rails and a Zicromount 3. The shorter length of the Z-arm keeps everything very compact. And because the Q-mount has the quick release and convenient tightening lever, the Odyssey can be spun to be viewable from either side of the camera.

Works great!

Products You May Like

Product ID : Z-MZR
Install one of these on each of your ¼ 20” devices and use our Zamerican Z-Rail Arm!
Product ID : Z-SARM
The Zamerican Z-Rail Small Arm is a 6” articulating arm that has two Z-Rail clamps on either end.
Product ID : ZUD 3/8 16
A ZUD 3/8 16 is a short female rod that ends in a 3/8 16 screw hole. It is primarily used to retrofit a Noga or Israeli arm that ends in a 3/8 16 screw to a...
Product ID : Z-DADPT
The Half Inch Adapter adapts a Zacuto rod or zamerican arm from 15mm to either a ¼” 20 or ⅜” 16 male screw.
Product ID : Z-ZENGL
This 12" arm kit is designed to go between a 1/4 20 screw and a 1/4 20 screws. It's usually used to attach a monitor to the top of a camera or camera handle.
Product ID : Z-LARM
The Zamerican Z-Rail Arm is a 12” articulating arm that has two Z-Rail clamps on either end.